Brother PT-E550W - Manual (Page 57)

Glossary
52
10
Using ARP to configure the IP address
10
If you are unable to use the BRAdmin application and your network does not use a DHCP server, you can
use the ARP command instead. The ARP command is available on Windows
® systems that have TCP/IP
installed. To use ARP enter the following command at the command prompt:
arp -s ipaddress ethernetaddress
ping ipaddress
Where ethernetaddress is the MAC Address (Ethernet Address) of the print server and ipaddress is
the IP address of the print server. For example:
 Windows ® systems
Windows ® systems require the dash “-” character between each digit of the MAC Address (Ethernet
Address).
arp -s 192.168.1.2 00-80-77-31-01-07
ping 192.168.1.2
NOTE
You must be on the same Ethernet segment (that is, without a router between the print server and
operating system) to use the arp -s command.
If there is a router, you may use BOOTP or other methods described in this chapter to enter the IP address.
If your administrator has configured the system to deliver IP addresses using BOOTP, DHCP or RARP your
Brother print server can receive an IP address from any one of these IP address allocation systems. In
which case, you will not need to use the ARP command. The ARP command only works once. For security
reasons, once you have successfully configured the IP address of a Brother print server using the ARP
command, you cannot use the ARP command again to change the address. The print server will ignore any
attempts to do this. If you wish to change the IP address again, use Web Based Management via the web
browser, or factory reset the print server (which will then allow you to use the ARP command again).