Installing the driver & software, Macintosh, Wlan enable? 1.on 2.off – Brother MFC 7840W User Manual
Page 39: Select ab or ok salesgroup, Select ssid&set <new ssid, Ssid, Mode select infrastructure
Installing the Driver & Software
37
Macintosh
®
M
acint
osh
®
Wir
e
less
Network
2
Plug the AC power cord into an AC outlet. Turn
the power switch on.
Improper Setup
If you have previously configured the wireless
settings of the machine you must reset the
network (LAN) settings before you can
configure the wireless settings again.
Press Menu, 5, 2, 6 (or Menu, 5, 0, 1) and then
press 1 to accept the change.
3
On your machine, press Menu, 5, 2, 2.
WLAN Enable?
1.On 2.Off
Press 1 to choose On. The wired network
interface will become inactive with this setting.
4
The machine will search for your network and
display a list of available SSIDs. You should
see the SSID you wrote down earlier. If the
machine finds more than one network use the
or
to choose your network, then
press OK. Go to step 8.
Select ab or OK
salesgroup
Note
It will take several seconds to display a list of
available SSIDs.
If your access point is set to not broadcast the
SSID you will have to manually add the SSID
name. Go to step 5.
5
Select <New SSID> using the
or
and
press OK. Go to step 6.
Select SSID&Set
<New SSID>
6
Enter a new SSID and press OK. For
information how to type text, see Entering
text on page 46.
SSID:
7
Press the
or
to choose
Infrastructure, then press OK.
Mode Select
Infrastructure
8
Use the
or
and OK keys to choose one
of the options below: If your network is
configured for Authentication and Encryption
you must match the settings used for your
network.
No Authentication or Encryption: Choose
Open System, press OK then choose None
for Encryption Type and press OK. Then
press 1 to apply your settings. Go to step 12.
No Authentication with WEP Encryption:
Choose Open System, press OK then use the
or
to choose WEP for the
Encryption Type and press OK. Go to
step 9.
Authentication with WEP Encryption:
Choose Shared Key, press OK. Go to step 9.
Authentication with WPA/WPA2-PSK (TKIP
or AES Encryption): Choose
WPA/WPA2-PSK, press OK. Go to step 10.
Authentication with LEAP: Choose LEAP,
press OK. Go to step 11.