Brother LX2375 - Manual (Page 15)

14
1
g
Guide the thread through the thread take-up
lever from right to left.
a Thread take-up lever
h
Put the thread behind the needle bar thread
guide above the needle.
The thread can easily be passed behind the
needle bar thread guide by holding the thread
in your left hand, then feeding the thread with
your right hand.
a Needle bar thread guide
i
Thread the needle from front to back and pull
out about 5 cm (2 inches) of thread.
a 5 cm (2 inches)
Note
● If the thread take-up lever is lowered, the
upper thread cannot be wrapped around the
thread take-up lever. Make sure you raise
the presser foot lever and the thread take-up
lever before you feed the upper thread.
● If you incorrectly feed the thread you may
cause sewing problems.
Drawing up the lower thread
a
Lightly hold the end of the upper thread.
a Upper thread
b
Turn the handwheel toward you
(counterclockwise) to lower the needle.
c
Turn the handwheel toward you
(counterclockwise) to raise the needle, pulling on
the upper thread to draw up the lower thread.
• Pull thread loop to finish threading process.
d
Pull out about 5 cm (2 inches) of both threads
and pull them toward the back of the machine
under the presser foot.
a Upper thread
b Lower thread
c 5cm (2 inches)