Brother LX2375 - Manual (Page 40)

APPENDIX —————————————————————————————————————————————————————
39
c
Remove the face plate from the machine.
Note
● Hold the face plate securely while removing
or attaching it.
d
Replace the sewing light bulb.
a bulb
b Loosen
c Tighten
e
Attach the face plate and fasten the screw
again.
Cleaning the machine
surface
If the surface of the machine is dirty, lightly soak a
cloth in neutral detergent, squeeze it out firmly, and
then wipe the surface of the machine. After cleaning it
once with a wet cloth, wipe it again with a dry cloth.
Cleaning the shuttle race
a
Turn off the machine and unplug it.
b
Raise the needle and the presser foot, and
then remove the presser foot and the needle.
c
Remove the flat bed attachment and open the
shuttle cover at the front of the free arm.
d
Remove the bobbin case by pulling its latch
toward you and pulling it out from the shuttle
race.
a Bobbin case latch
e
Slide the latch levers out from the retaining
ring to remove it.
a Retaining ring
b Latch lever
● Unplug the power supply cord before
cleaning the machine, otherwise injuries or an
electric shock may occur.
CAUTION
● Be sure to unplug the machine before
cleaning it, otherwise injuries or an electric
shock may occur.
CAUTION