Installing the printer driver, Macintosh – Brother HL-5280DW User Manual
Page 47
Installing the Printer Driver
45
Mac
in
to
s
h
®
W
irel
ess
Network
Macintosh
®
10
If more than one wireless printer is available on
the network, the following list appears. If the list
is blank, check if the access point and the
printer are powered on, and then click Refresh.
Choose the printer you wish to configure, and
click Next.
Note
• The Default Node name of the printers network
card is "BRW_XXXXXX" (where "XXXXXX" is the
last six digits of the Ethernet address).
• If you are using Personal Firewall software,
temporarily disable it.
11
The wizard will search for wireless networks
available from your printer. If more than one
wireless network is available, the following list
appears. Choose the wireless network you
wish to associate the printer with, and then
click Next.
Note
• “SETUP” is the default SSID of the printer. Do not
choose this SSID.
• If the list is blank, check that the printer is within
range of the access point for wireless
communication. Then, click Refresh.
• If your target wireless network does not appear on
the list, you can manually add it by clicking the
Add button. Follow the on-screen instructions for
entering the Name (SSID) and the Channnel
number.
12
If your network is not configured for
Authentication and Encryption, the following
screen will appear. To continue installation,
click OK. Go to Step
14.
13
If your network is configured for Authentication
and Encryption the following screen will
appear. When configuring your Brother
wireless printer, you must ensure that it is
configured to match the Authentication and
Encryption settings of your existing wireless
network. Choose the Authentication Method
and Encryption Mode from the pull-downs in
each setting box. Then enter the Network Key
and click Next.
Note
• If you want to set more than one WEP key, click
Advanced.
• If you want to configure LEAP security, see the
Network User’s Guide.
• If you do not know the Authentication or
Encryption settings for your network contact your
network administrator.