Canon Wireless File Transmitter WFT-E7A - Manual (Page 36)

36
Automatic Image Transfer After Each Shot
To transfer smaller JPEGs when the camera is set up to record larger JPEGs to one card
and smaller JPEGs to the other, set [JPEG size to trans.] to [Smaller JPEG].
To transfer either RAW or JPEG images when the camera is set up to record RAW images
to one card and JPEGs to the other, specify which images to transfer in the [RAW+JPEG
transfer] setting. Similarly, complete the same setting when RAW+JPEG images are
recorded simultaneously to a single memory card.
When images of the same size are recorded to both cards simultaneously, images recorded
to the CF card are transferred, regardless of image quality (compression).
If transfer fails, an error number is displayed on the
transmitter’s LCD panel, and the <LAN> lamp blinks in
red.
In this case, see page 98 to eliminate the cause of the
error.
Once the cause of the error is eliminated, the images
whose transfer previously failed will be transferred
automatically. With this option activated, transfer is attempted again automatically after failure,
both when shooting with automatic transfer and when transferring captured images via FTP.
Note that when you cancel image transfer, or turn off the transmitter or camera, the image will
not be re-transferred automatically. See page 40 and transfer the image manually.
In the menu, select [Communication settings]  [Network settings]  [Set up] 
[LAN power save].
When this option is set to [Enable], the transmitter will log off from the FTP server after
transfer and switch to standby mode. Wireless and wired connectivity will be restored
automatically when you attempt to transfer images, and the transmitter will reconnect to the
FTP server.
Auto Retry if Transfer Fails
Enabling LAN Power Management
COP
Y