Canon imageCLASS MF4880dw - Manual (Page 5)

5
Setting the Wireless LAN

• You should press the WPS button within 2
minutes after you select <Yes> in step .
• Press and hold * the button until the lamp lights
or blinks.
* The time that you should hold the button may vary
depending on the router you are using.

• After the <Connected.> screen is displayed,
wait until the Wi-Fi indicator stops blinking and
turns on.
When an error message appears:
Press [OK] to close the screen, check whether or
not the network key is correct, and then retry the
settings.
If the access point cannot be detected even after
retrying, see the following.
“When an Error Message Appears” (P.14)
When checking the network connection:
You can check if the machine is properly connected
to the network using a computer that is connected
to a network.
”Checking that the Wireless LAN Setting is
Completed” (P.9)
When setting an IP address manually:
“Setting the IPv4 Address” in the e-Manual
Wait approximately 2 minutes
after the connection is completed.
The IP address is set during this time period.
Move to the machine
Proceed to P.9
Prepare for Wireless LAN Connection
1
Setting the Wireless LAN
2
Installing the Software
3
Troubleshooting
4