Shooting movies, Ç contents ç chapter contents – Canon PowerShot ELPH 150 IS User Manual
Page 184
184
ç Contents
ç Chapter Contents
White dots or similar image artifacts appear in flash shots.
•
This is caused by light from the flash reflecting off dust or airborne
particles.
Shots look grainy.
•
•
High ISO speeds in some shooting modes may cause grainy images
(
).
Subjects are affected by red-eye (
).
•
) to activate the red-eye reduction
) in flash shots. Note that while the red-eye reduction lamp
is on (for about one second), it is not possible to shoot, because the lamp
is counteracting red-eye. For best results, have subjects look at the red-
eye reduction lamp. Also try increasing the lighting in indoor scenes and
shooting at closer range.
•
Edit images using red-eye correction (
).
Recording to the memory card takes too long, or continuous
shooting is slower.
•
Use the camera to perform low-level formatting of the memory card
(
).
Shooting settings or FUNC. menu settings are not available.
•
Available setting items vary by shooting mode. Refer to “Functions
Available in Each Shooting Mode”, “FUNC. Menu”, and “Shooting Tab
Menu” (
).
Shooting Movies
The elapsed time shown is incorrect, or recording is
interrupted.
•
Use the camera to format the memory card, or switch to a card that
supports high-speed recording. Note that even if the elapsed time display
is incorrect, the length of movies on the memory card corresponds to the
actual recording time (