Connecting the camera and computer, Cop y – Canon EOS Rebel T5 18-55 IS II Kit User Manual
Page 6
5
Connecting the Camera and Computer
To download to your computer images shot with your camera, you will
need to connect your camera and computer using the interface cable
provided with the camera.
1
Connect the large plug of the cable into the USB port
of your computer.
For the location and direction of the USB port, refer to the user's
manual for the computer.
2
Connect the small plug of the cable into the terminal
on your camera.
Once the plug is connected to the camera according to the steps
for your camera model, preparation for downloading images is
complete. Refer to “
Confirming Computer Settings” to check
the settings of the computer, and continue with “Starting up EU”
.
With the <
> mark on the plug facing the back of the camera,
connect it to the camera’s <A/V OUT / DIGITAL> terminal.
1D Mk IV
Cameras other than
With the <
> mark on the plug facing the front of the camera,
connect it to the camera’s <
> terminal or <A/V OUT /
DIGITAL> terminal.
1D Mk IV
Confirming Computer Settings
Before you start up EU, connect the camera and the computer
and set the camera's power switch to <ON>, then make sure that
the following settings are applied to your computer. If these are
not applied, adjust the settings as follows.
Select [Applications]
[Image Capture]. Double-click the
icon of the camera connected to the computer.
Set
[Connecting this camera opens] to [No application].
After confirming and adjusting the settings, set the camera's
power switch to <OFF>.
To start up EU, you must connect your camera to the same USB
port as when you confirmed and adjusted the settings.
To use another USB port, confirm and adjust the settings again.
With
, you can fix the
plug to the camera with the cable protector to prevent the plug
from disconnecting. For details on using, see
.
1D X
1D C
1D Mk IV
1Ds Mk III
1D Mk III
COP
Y