Canon imagePROGRAF iPF825 User Manual
Page 749
Setting Item
Description, Instructions
(The type of paper is dis-
played here.)
(*1
)
Scan Wait Time
Specify the time to wait for the ink to dry between each
scan (after the printhead finishes moving in one direction),
in consideration of how quickly the ink dries. Also specify
the applicable area for the ink drying time. Select Entire
area to apply the ink drying time after each scan until the
document is fully printed. Select Leading edge to apply
the ink drying time after each scan only in the area 110–
1
60 mm from the leading edge. (The applicable length
varies depending on the Print Quality setting.) Note that
printing will take longer if you specify the Scan Wait
Time setting. In particular, when Leading edge is selec-
ted, colors may be uneven in the boundary between the
areas with and without a drying time.
Feed Priority
Specify exact paper feeding, if desired. Normally, select
Automatic. Choose Print Length if you prefer to feed the
paper an exact amount. However, note that choosing Print
Length may result in slight banding in the direction of
Carriage scanning.
Adjust Length
Displayed if Feed Priority is Print Length.
Adjustment relative to the amount of stretching or shrink-
age of the current paper.
Enter either the adjustment results from Print Pattern or
the discrepancy that you measured (as a percentage).
For paper that tends to stretch, increase the feed amount
by choosing a higher adjustment value. For paper that
tends to shrink, decrease the feed amount by choosing a
lower adjustment value.
Head Height
Skew Check Lv.
If you print on Japanese paper (washi) or other handmade
paper that has an irregular width, choose Loose for a high-
er skew detection threshold, or choose Off to disable skew
detection. However, if paper is loaded askew when detec-
tion is Off, note that paper jams or Platen soiling may oc-
cur.
VacuumStrngth
Specify the level of suction that holds paper against the
Platen. (See "Adjusting the Vacuum Strength (Vac-
uumStrngth).")
Width Detection
Specify this option to print inside boundaries or in other
cases when specifying a particular starting position for
printing. Paper width and skew are not detected if you se-
lect Off. If paper is loaded askew, note that paper jams or
Platen soiling may occur.
NearEnd RollMrgn
Specify the minimum margin at the leading edge of roll
paper to ensure better printing quality at the leading edge.
Note that if you choose 3mm, it may lower the printing
quality at the leading edge and affect feeding accuracy.
The printed surface may be scratched, and ink may adhere
to the leading edge. It may also cause the Platen to be-
come soiled.
Printer Parts
>
Control Panel
>
iPF825
Main Menu Settings
9
733