Canon Wireless Transmitter WFT-E5A - Manual (Page 71)

71
Setting Up Linked Shooting
5 Set up the master camera.
Configure the settings on the master camera
following steps 1-3 on the previous page, and then
select [Master].
X The following screen is displayed.
6 At this point, switch to setting up the
slave cameras.
On the slave cameras, select [OK].
7 Check the number of slave cameras.
X On the master camera LCD monitor, the number of
slave cameras detected is displayed.
8 Establish the connection.
On the master camera and all slave cameras,
select [OK].
X A screen is displayed as the connection is tested.
The information you specified is stored on the
cameras. It is not stored on the transmitters.
COP
Y