Canon EOS Rebel T5 18-55 IS II Kit - Manual (Page 284)

284
If a problem occurs with the camera, first refer to this Troubleshooting
Guide. If this Troubleshooting Guide does not resolve the problem,
contact your dealer or nearest Canon Service Center.
Do not use any battery pack other than a genuine Canon Battery Pack
LP-E10.
If the battery charger has a problem, the protection circuit will stop the
charging and the charge lamp will blink in orange. If this happens,
unplug the charger’s power plug from the power outlet and detach the
battery pack. Attach the battery pack to the charger again and wait a
while before connecting the charger to a power outlet again.
Make sure the battery is properly installed in the camera (p.32) .
Make sure the card slot/battery compartment cover is closed (p.32) .
Recharge the battery (p.30) .
Press the <B> button (p.52) .
If the power is turned off while an image is being recorded to the card,
the access lamp will remain on or continue to blink for a few seconds.
When the image recording is completed, the power will turn off
automatically.
Troubleshooting Guide
Power-Related Problems
The battery pack does not recharge.
The battery charger’s lamp blinks.
The camera does not operate even when the power
switch is set to <1>.
The access lamp still remains on or blinks even when
the power switch is set to <2>.
COP
Y