Electrolux EW30GC60IS - Manual (Page 15)

15
Surface Burner
Grate
Surface Burner
Caps
Surface Burner
Head
CautioN
- use caution when replacing the burner head so the electrode is not damaged. a damaged electrode
may cause a delayed ignition or prevent the burner from igniting
- Any additions, changes or conversions required in order for this appliance to perform satisfactorily
must be made by a qualified service technician.
General Care & Cleaning
cleaninG tHe buRneR GRates, buRneR caPs and
buRneR Heads
The Grates, Burner Caps and the Large 18k Burner Head should
be routinely cleaned. Keeping the burner ports clean will prevent
improper ignition and an uneven flame. If needed, the fixed burners
should be cleaned in place with an humid cloth (do not spray water
on them).
Refer to the following instructions:
To Remove and Replace the Surface Burner Grate, Surface
Burner Cap and Surface Burner Head- Remove in the following
order; (1st) Surface Burner Grate, (2nd) Surface Burner Cap, (3rd)
Surface Burner Head (See Figure 1).
Reverse the procedure above to replace the Surface Burner Cap,
Surface Burner Head and Surface Burner Grate. Do not remove
any burner parts from the cooktop until the burner parts have
completely cooled and are safe to handle. Do not operate the
surface burners without the Surface Burner Heads, Surface
Burner Caps and Surface Burner Grates properly in place.
To Clean the Burner Caps, Burner Heads and Burner Grates -
Use a soap-filled scouring pad or a mild abrasive cleaner to clean
the surface burner caps and surface burner heads. The Grates are
designed to be Dishwasher safe for cleaning. The ports (or slots)
around the burner heads must be routinely cleaned. If residue still
remains in these ports, use a small-gauge wire or needle to clean the slots or holes being
careful not to damage the electrode. For proper flow of gas and ignition of the burner— DO
NOT ALLOW SPILLS, FOOD, CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER
THE GAS ORIFICE HOLDER OPENING. ALWAYS make sure that the surface burner cap,
the surface burner head and the surface burner grate are properly in place whenever a surface
burner is in use.
tHe cooktoP is not ReMovable. Do not attempt to remove or lift the cooktop.
1st 2nd
3rd
Orifice Electrode
Surface
Burner
Head
Surface
Burner
Cap
Figure 1
Surface Burner Grate