Electrolux EHG6341FOK - Manual (Page 13)

Problem Possible cause Remedy
The residual heat indica-
tor does not comes on. The cooking zone is not
hot because it operated
only for a short time. If the cooking zone oper-
ated sufficiently long to
be hot, speak to the serv-
ice centre.
The Automatic Heat Up
function does not oper-
ate. The cooking zone is hot. Let the cooking zone be-
come sufficiently cool.
The highest heat setting
is set. The highest heat setting
has the same power as
the Automatic Heat Up
function.
You decreased the heat
setting from
.
Start from and only in-
crease the heat setting.
The heat setting changes
between two levels. The Power management
is activated. Refer to “Power manage-
ment”.
You cannot activate outer
ring. Activate the inner ring
first.
The sensor fields become
hot. The cookware is too large
or you put it too near to
the controls. Put large cookware on
the rear cooking zones if
it is necessary.
comes on. The Automatic Switch Off
operates. Deactivate the appliance
and activate it again.
comes on. The Child Safety Device
or the Lock function op-
erates. Refer to the chapter “Dai-
ly Use”.
comes on. No cookware is on the
cooking zone. Put cookware on the
cooking zone.
The cookware is incor-
rect. Use the correct cook-
ware.
The diameter of the bot-
tom of the cookware is
too small for the cooking
zone. Move cookware to a
smaller cooking zone.
and number comes
on.
There is an error in the
appliance. Disconnect the appliance
from the electrical supply
for some time. Discon-
nect the fuse from the
electrical system of the
house. Connect it again.
If
comes on again,
speak to the service cen-
tre.
ENGLISH 13