Electrolux EQT4520BOG - Manual (Page 9)

To deactivate the function: touch .
The roasting zones operate independently.
4.5 Timer
Count Down Timer
You can use this function to set how long
the roasting zone operates for only this
one time.
First set the roasting zone then set
the function. The selection of the Timer
function is possible for roasting zones that
are active and after the temperature is set.
To set the roasting zone: touch
again and again until the indicator of a
necessary roasting zone comes on. When
this function is active, comes on.
To activate the function: touch of
the timer to set the time ( 00 - 99 minutes).
When the indicator of the roasting zone
starts to flash slowly the time counts
down.
To see the remaining time: set the
roasting zone with . The indicator of the
roasting zone starts to flash quickly. The
display shows the remaining time.
To change the time: set the roasting
zone with . Touch or .
To deactivate the function: set the
roasting zone with and touch . The
remaining time counts back to 00. The
indicator of the roasting zone goes out.
When the time comes to an
end, the sound operates and
00 flashes. The roasting zone
deactivates.
To stop the sound: touch .
CountUp Timer (The count up
timer)
You can use this function to monitor how
long the roasting zone operates.
To set the roasting zone (if more than
1 roasting zone operates): touch
again and again until the indicator of a
necessary roasting zone comes on. When
this function is active, comes on.
To activate the function: touch . The
symbol goes out and comes on.
To see how long the roasting zone
operates: set the roasting zone with .
The indicator of the roasting zone starts to
flash quickly. The display shows how long
the zone operates. During the first minute
the display shows the time in seconds.
After the first minute the display shows the
time in minutes.
To deactivate the function: set the
roasting zone with and touch . The
symbol goes out and comes on.
To reset the function: touch . The
time counts back to 00.
If two functions operate at the
same time, the display shows
the CountUp Timer function
first.
Minute Minder
You can use this function as a Minute
Minder when the hob is activated and the
roasting zones do not operate (the
temperature display shows ).
To activate the function: touch .
Touch or of the timer to set the
time. When the time comes to an end, the
sound operates and 00 flashes.
To stop the sound: touch .
The function has no effect on
the operation of the roasting
zones.
4.6 Lock
You can lock the control panel while
cooking zones operate. It prevents an
accidental change of the heat setting.
Set the heat setting first.
To activate the function: touch .
comes on for 4 seconds. The Timer stays
on.
To deactivate the function: touch .
The previous heat setting comes on.
ENGLISH 9