Bosch HES7282U - Manual (Page 21)

Operation - Cooktop
English 17
To turn on all three elements, Push in and turn the control knob to the icon.
Turn knob left or right to set the heat level.
Bridge Element Control Knob
(some models) The bridge element connects two single elements to create one long cooking sur-
face.
Depending on the model, the bridge element is either activated in conjunction with
the front single element ( ) or the rear single element ( ). Refer to the control
knob on your appliance to determine your configuration.
Turn ON the bridge element and the small element together
1.
Push in on the control knob and turn clockwise to the desired heat setting.
Tip: To complete the connection and create an even longer cooking surface ,
turn ON the other single element, too.
To use the single element without bridge
1.
Turn the knob counterclockwise.
Surface Elements Disabled During
Self Clean (some models) Two or more surface elements are automatically disabled during Self-Clean
Operation only. This is normal. Once the Self-Clean cycle is complete and the
oven has cooled, the elements become operable once again.
Figure 11: Triple Element Knob
Inner
Element All Three
Inner and Middle Element
Elements
Only
Figure 12: Bridge Element Knob
Front Single Element Element Location
Bridge Element with
Front Single Element
Rear Single Element Element Location
Bridge Element with
Rear Single Element
Bridge element activated with Bridge element activated with
front single element:
rear single element:
WARNING:
To avoid risk of personal injury, do not operate the cook top and
ensure that all surface controls are turned off while the self clean
cycle is operating.