Night Guard Home Surveillance System C3-RS-601 - Manual (Page 14)

7/9/2008
RS-603 REV A. 14
SHUTDOWN DIAGNOSTICS
The unit has the ability to report the cause of the last shutdown of the remote start system.
Enter:
1. Turn the Ignition 'switch to ‘ON position.
2. Press the button on the transmitter.
3. The LED will now report the last system shutdown by flashing for one minute in the following grouped patterns:
LED
Flashes Shutdown Mode
1
(-) Safety Shutdown input (Hood)
1. Close the hood.
2. Check H3/3 White/ Black wire connection.
1 (+) Safety Shutdown input (Brake) or 3. Check H3/5 White/ Violet wire connection.
1 Neutral Safety Switch input fail. 4. Move the Enable Toggle Switch to “ON”
position. (If installed.)
5. Move the gear selector to “Park”/ “NEUTRAL”
position.
6. Check H3/4 Black/White wire connec tion.
3 No RPM or
Low Voltage. TACHOMETER CHECKING TYPE:
Check H3/1 White/Red wire connection
VOLTAGE CHECKING TYPE:
Program the “CHECK LEVEL” from
“Hi Check Level” to “Low Check Level”
5 Over-rev
6 System timed out
7 Transmitter No transmitter Signal
8 Tach. Signal has not been learned
Re-learning the RPM (Feature
IV – 2
)
TROUBLE SHOOTING
There are 5 reasons why the remote start button will not respond from the transmitter.
1. The Black/White Neutral Safety wire is not grounded. Must be grounded to start.
2. Hood Pin switch White/Black wire has a ground present. Must not show ground to start.
3. Brake pedal switch White/Violet has 12 volt present. Must not show 12 volt to start.
4. The system is in Valet mode.
5. The remote start feature programming has not been programmed to start the vehicle. The remote start must be
programmed how to start the vehicle.
TESTING YOUR INSTALLATION:
Caution!! The following procedure must be performed after the installation of the Remote Start Device. It is the responsibility
of the installing technician to complete these tests. Failure to test the unit in the following manner may result in personal
injury, property damage, or both.
1. Test the BRAKE shutdown circuit: With the vehicle in park (P), start the vehicle using the remote transmitter, Once the
engine is running, press the brake pedal. The vehicle should shut down immediately. If the vehicle continues to run, check
the brake circuit WHITE/ VIOLET
wire (H3/3) connection.
2. Test the HOOD PIN shutdown circuit: Start the vehicle using the remote transmitter, Once the engine is running, pull the
hood release and raise the hood. The vehicle should shut down immediately. If the vehicle continues to run, check the
hood pin WHITE/ BLACK wire (H3/4) connection.
3. NEUTRAL START SAFETY TEST:
1. Set the vehicle parking brake.
2. Block the drive wheels to prevent vehicle movement.