Water Inc EVERBREW1033518 - Manual (Page 6)

Page 6
MAKING COFFEE:
4. Press the volume selection button that corresponds to the amount desired. (Full Pot, Half Pot or Quarter Pot)
5. In less than a minute, fresh hot coffee will begin to flow from the brew cone into the decanter or thermos.
WARNING: Hot coffee can cause serious burns. Make sure that the coffee has stopped coming out of the brew cone before you remove it from the coffee
appliance. HANDLE HOT COFFEE CAREFULLY.
6. After the brewing cycle is complete, remove the brew cone and discard the used coffee grounds and paper filter. Rinse the brew cone with water and place it
back into the coffee appliance.
7. To brew another decanter or thermos of coffee, repeat instruction steps 1 thru 6.
CAUTION: Make sure decanter or thermos is empty of coffee before brewing again.
ADJUSTMENTS
PROGRAMMING YOUR EVERBREW: (See Fig. 7)
SETTING THE CLOCK:
1. Press and hold the program button for 3 seconds; the display will first show the brew time, press once again and the display will show the clock
time as indicated by the flashing colon (:).
2. To set hours, press and hold the plus (+) button; hours on display will advance from 00 to 12pm. PM time is set when the green dot is lit next to the
“PM” in the upper left corner of the display box.
3. To set minutes press and hold the minus (-) button; minutes will advance from 00 to 59.
4. After setting the clock, press the program button twice to exit from the
menu.
NOTE: This machine is preset at the factory for the following settings:
FACTORY PRESET SETTINGS:
Volume Settings: Full Brew: (64 oz) 7:00 Minutes Half Brew (32 oz): 3:30 Minutes Qtr. Brew (16 oz): 1:45 Minutes
RESETTING THE VOLUME: (Amount of Coffee to be brewed)
NOTE: When making volume adjustments, always be sure an empty container with 64 ounces capacity is under the brew cone and the power is ON.
1. Press and Hold the “PROGRAM” button approximately 3 seconds until the display changes and the set light flashes, then press the “PROGRAM”
button two (2) times. The display window will now be blank.
2. Press the “FULL BREW SELECTION” button. Note the display will start counting minutes and seconds and water will start to flow into the container.
When desired volume has been reached, press the “FULL SELECTION” button to stop the water flow. If more water is needed, press the “FULL
SELECTION” BUTTON repeatedly until desired level is reached. After the “SELECTION” buttons is programmed, press the “PROGRAM” button to exit
the Program mode
.
3. To program the “HALF BREW SELECTION”, follow steps 1 & 2 instructions above using the “HALF BREW SELECTION” button. After the
“SELECTION” buttons is programmed, press the “PROGRAM” button to exit the Program mode .
4. To program the “QTR. BREW SELECTION”, follow steps 1 & 2 instructions above using the “QTR. BREW SELECTION” button. After the
“SELECTION” buttons is programmed, press the “PROGRAM” button to exit the Program mode .
Fig. 7