Water Inc EVERBREW1033518 - Manual (Page 7)

Page 7
SETTING AUTOMATIC BREW TIME:
1. Press and hold the “PROGRAM ” button for 3 seconds, the display will show 00:00 or the default brew time. (Note: you have 30 seconds to begin
entering the brew time.)
2. To set hours, press and hold the (+) button; hours on the display will advance from 00 to 12pm. PM time is set when the green dot is lit next to the
“PM” in the upper left corner of the display box.
3. To set minutes, press and hold the minus (-) button; minutes will advance from 00 to 59.
4. To set the volume option, (amount of coffee to be brewed), press the button that corresponds to the amount desired (full pot, half pot, quarter pot
options). The light will light when the button is selected.
5. After setting the brew time, press the program button once to exit from the menu. The display will show the current time and the light next to the
volume selection button will be flashing.
Note: The clock must be set in order to have “Brew Start Time” functioning.
6. To cancel the programmed Brew Time, press and hold the “PROGRAM” button. Release button when the time comes on. Display will show the actual
programmed brewing time, press the flashing “VOLUME SELECTION LIGHT” button, the light will turn off and same for the “Set” light. Press the
“PROGRAM” button again to exit the Program Mode.
7. To re-program a different “VOLUME SELECTION” brew button option: Press and hold “PROGRAM” button. Release button after the display changes,
press a different “VOLUME SELECTION” brew button to change the existing programmed brew button. The previous assigned “VOLUME SELECTION”
brew light will turn off. Press the “PROGRAM” button to save the change and to exit the Program Mode.
Note: Brewing coffee while the “Brew Start Time” is set, will cancel the current “Brew Start Time”, repeat steps 1 through 5 to re-program.
Note: “Brew Start Time” is set for one brew cycle only. This coffee maker will not automatically revert to the preset brew time. This function must be re-
programmed each time.
WARNING: Always make sure an empty container such as a glass decanter, stainless steel decanter or thermos is placed directly beneath the coffee
appliance brew cone when a “Brew Start Time” is set.
If this coffee appliance should fail to function properly, unplug it and contact Water Inc. at 800-322-9283
MAINTENANCE & CLEANING
CAUTION: Only those persons trained and qualified in equipment repair should attempt to
open and clean the inside of this coffee appliance.
CAUTION: Turn the power switch off, unplug the power supply cord and allow the coffee
appliance to cool before cleaning.
Note: Do not use abrasive or harsh cleaners as they may damage the finish of this
coffee appliance.
Note: Failure to follow these cleaning instructions may damage this coffee appliance
and may void the warranty.
As needed, clean stainless steel surfaces with a mild, non-abrasive stainless steel cleaner.
Other surfaces can be cleaned with a soft damp cloth or mild liquid detergent.
The brew cone should be rinsed with water after each brew cycle. At least once a week the
brew cone should be washed by hand with a mild detergent. Rinse well after washing.
As necessary, the area between the brew cone rails and above the brew cone should be
wiped clean with a damp cloth as coffee oils will gradually collect on these surfaces. (Fig. 8)
Once a week, more often in hard water areas, the spray head, located above the brew cone,
should be removed and cleaned.
Fig. 8
Fig. 9