Aviom A-16CS - Manual (Page 61)

51
Note: Remember that the R
EMOTE
/L
OCAL
button on the
front panel of the A-16R must be in the R
EMOTE
position to save or recall Presets from the A-16CS.
Display the Current Preset Number
This function displays the last recalled or saved Preset number when
in Save Mode. This is useful when editing Presets to help avoid
overwriting a Preset you want to preserve in memory.
In Save Mode the current Preset will blink on the A-16CS channel
button LED’s. To check the current Preset:
• Hold down the R
ECALL
and G
ROUP
buttons.
• The current Preset number’s LED blinks.
• Release the
R
ECALL
and G
ROUP
buttons to exit without
saving a Preset
• To save a Preset, press any Channel button; the Preset
is saved to that location.
When checking the current Preset by using this method, remember that
the system does not indicate that the Preset may have been modified. It
simply indicates the last Preset recalled or saved.
The A-16CS Rear Panel
On the rear panel of the A-16CS Control Surface you will find only
two jacks, one for a footswitch, the other for the A-Control input.
A-Control
Communication between the A-16CS and its host A-16R is managed
by a proprietary protocol known as A-Control. This allows the remote
A-16CS to send commands to the A-16R mixer for creating and editing
mixes, and for storing and recalling Presets.
All A-16R front-panel editing commands are available from the
A-16CS. You cannot, however control the analog insert send and return
jacks or the Mix In level from the A-16CS. These are analog controls.
A single Cat-5 cable is used to connect the A-16CS to the A-16R.
Cables can be up to 200 feet in length.