Saving all mix presets via midi – Aviom A-16CS User Manual
Page 68
58
Aviom A-16R and A-16CS User Guide
2. Set the A-16R front panel Remote/Local switch to the
L
OCAL
(MIDI On) position.
3. Set up your MIDI recording device so that it is ready to
receive MIDI SysEx data.
4. Hold the
R
ECALL
and G
ROUP
buttons down to enter
Save Mode.
5. While still holding the
R
ECALL
and G
ROUP
buttons,
press the
S
OLO
button. (After pressing the S
OLO
button,
you can release the
R
ECALL
and G
ROUP
buttons.)
6. The current mix is sent out from the A-16R to the MIDI
recording device as a data dump.
7. Save your MIDI SysEx data to disk or other storage
media used by your MIDI recording device or software
application.
When transmitting a single Preset, the sixteen yellow Mute LEDs
will light solid for the duration of the transmission to verify the
send operation. For single preset file dumps this will be relatively
brief. (Note that there is no way that the A-16R can know that the
MIDI Preset data file was received properly by the device that the
transmission was intended for.)
Saving All Mix Presets via MIDI
To save the currently saved set of sixteen mix Presets as a single MIDI
SysEx data file:
1. Make sure that the A-16R front panel
R
EMOTE
/L
OCAL
switch is set to the
L
OCAL
(MIDI On) position.
2. Set up your MIDI recording device so that it is ready to
receive MIDI SysEx data.
3. Hold the A-16R front panel
R
ECALL
and G
ROUP
buttons
down to enter Save Mode.
4. While still holding the
R
ECALL
and G
ROUP
buttons,
press the
M
UTE
button. (You can then release the
R
ECALL
and G
ROUP
buttons.)
5. The contents of the internal memory of the A-16R
is sent to the MIDI recording device as a single data
dump.
6. Save your MIDI SysEx data to disk or other storage
media as used by your MIDI recording device.
During the transmission of the Preset memory, the sixteen yellow
Mute LEDs in the Channel buttons will light solid for the duration of
the SysEx transmission.
Note that only the sixteen saved Presets are transmitted as MIDI data.