Wwarning, 17 connecting the water supply – LG LMC25780SB User Manual

Page 17

Advertising
background image

17

CONNECTING THE WATER SUPPLY

w

WARNING

Connect to safe drinking water supply
only.

• The water pressure must be between 21 and

121 p.s.i. (1.5~8.5 kgf/cm

2

) on models without a

water filter and between 43 and 121 p.s.i.
(3~8.5 kgf/cm

2

) on models with a water filter.

• If water pressure does not reach 21 psi

(1.5kgf/cm

2

) or falls below, it is necessary to

purchase a separate pressure pump for normal
automatic icemaker and water dispensing operation.

• It is recommended that the total length of the

water feed tube does not exceed 26 ft. (8 m).

• Install the water supply line where it will not be

affected by heat.

IMPORTANT: Read all directions thoroughly
before you begin.

• If operating the refrigerator before installing the

water connection, turn the icemaker to the OFF
position to prevent operation without water.

• All installations must be in accordance with local

plumbing code requirements.

• Use copper tubing and check for leaks.

• Install tubing only in areas where temperatures

will remain above freezing.

• It may take up to 24 hours for the icemaker to begin

producing ice.

Tools Required

• Standard screwdriver

• 7/16-in. and 1/2-in. open-end wrenches or two

adjustable wrenches

• 1/4-in. nut driver

• 1/4-in. drill bit

• Hand drill or electric drill (properly grounded)

NOTE: Refrigerator dealers offer a kit with a 1/4-in.
saddle-type shutoff valve, a union, and copper tubing.
Before purchasing, make sure a saddle-
type valve complies with local plumbing codes.

Do not use a piercing-type or 3/16-in. saddle valve
which reduces water flow and clogs more easily.

NOTE: The Commonwealth of Massachusetts
Plumbing Code 248CMR shall be adhered to.

Saddle valves are illegal and use is not permitted in
Massachusetts. Consult with your licensed plumber.

Cold Water Supply

• The icemaker water valve contains a flow washer

which is used as a water pressure regulator.

• The icemaker needs to be connected to a cold water

line with water pressure between 21~121 psi
(1.5~8.5 kgf/cm

2

) on models without a water filter

and between 43 and 121 p.s.i. (3~8.5kgf/cm

2

) on

models with a water filter.

Advertising
This manual is related to the following products: