LG LMC25780SB - Manual (Page 23)

23
ENSURING PROPER AIR CIRCULATION
In order to ensure proper temperatures, air must flow
between the refrigerator and freezer sections.
As shown in the illustration below, air enters at top of
the freezer and circulates down.
From the bottom of the freezer, air is forced up to the
top of the refrigerator. Air enters refrigerator through
the top vent, then circulates and exists at the bottom,
where it returns to the freezer.
MULTI-FLOW
• Multi-Flow means powerful and effective cooling
operation. This is especially noticeable when new
food is placed in the refrigerator compartment.
• If water or foreign substances enter the cool air vent
while cleaning, efficiency will be lowered. In
addition, if gasket is damaged, efficiency may be
lowered because of escaping cool air.
Do not block any of cool air vents with food
packages. If the vents are blocked, airflow will be
interrupted and temperature and moisture problems
may occur.
IMPORTANT: Because air circulates between both
sections, any odors formed in one section will transfer
to the other. You must thoroughly clean both sections
to eliminate odors. To prevent odor transfer and
drying out of food, wrap or cover foods tightly. (See
the Food Storage Guide section for details.)
SETTING THE CONTROLS
• Your refrigerator has two controls that let you regulate
the temperature in the freezer and refrigerator
compartments.
• Initially set the REFRIGERATOR CONTROL at 37°F
(3°C) and the FREEZER CONTROL at 0°F (-18°C).
Leave it at this setting for 24 hours (one day) to
stabilize. Then adjust the compartment temperature as
desired.
• Refrigerator control: 33°F to 46°F (0°C to 8°C)
The lower the number setting, the colder the
refrigerator compartment will become.
• Freezer control: -6°F to 8°F (-21°C to -13°C)
When the setting is at a lower number, the freezer
compartment becomes colder. But the refrigerator
compartment becomes warmer because less cold air
flows into the refrigerator.
• ICE PLUS:
Press the ICE PLUS key and the LED will turn on.
This function will remain activated for 24 hours and
intensify the cooling speed of freezer and increase
the amount of ice.
NOTE: If you want to change °F to °C, press and hold
COLDER key of freezer and COLDER key of refrigerator
over 5 seconds at the same time. and if you want to
change °C to °F, hold them for 5 seconds again.
w CAUTION
Display mode setting and its cancellation
• To enter this mode, raise either the Refrigerator or Freezer
temperature to its highest setting. Then, press and hold
WARMER Key for 5 seconds.
• Perform the same way again to cancel the display mode.