LG DLG4802W - Manual (Page 26)

26 InstallatIon InstrUCtIons
Installation test (Exhaust check)
Once you have completed the installation of the dryer, use this
test to make sure the condition of the exhaust system is adequate
for proper operation of the dryer. This test should be performed
to alert you to any serious problems in the exhaust system of your
home.
• Your dryer features FLOW SENSE TM , an innovative sensing system
that automatically detects blockages and restrictions in dryer
ductwork. Keeping ductwork clean of lint buildup and free of
restrictions allows clothes to dry faster and reduces energy use.
The dryer should be cool before starting this test. If the dryer was
warmed up during installation, run the AIR DRY cycle for a few
minutes to reduce the interior temperature.
To activate the Installation test:
1. Press and hold the TEMP. and SIGNAL buttons at the same
time. While holding these buttons, press POWER ON/OFF
2. The dryer will show lnS in the number display to indicate that
it is in duct condition testing mode.
3. Press the START/PAUSE button.
The dryer will run for approximately 2 minutes to test for
blockages or restrictions to air flow in the ductwork.
4. Check the display for results.
During the two minute test cycle, monitor the FLOW SENSE
display on the control panel. If FLOW SENSE is displayed, when
the cycle ends, the exhaust system is adequate. If the exhaust
system is severely restricted, the display will show FLOW
SENSE. Other problems may also be shown with error codes.
Refer to the next page for error code details and solutions.
FLOW SENSE indicates that the exhaust system is severely
restricted. Have the system checked immediately, as performance
will be poor.
5. END of Cycle.
At the end of the test cycle, will display. The test cycle
will end and the dryer will shut off automatically after a short
delay.
notE
Lighting : Restricted
3828EL2001F_en_110519.indd 26 5/19/11 2:56:26 PM