LG 37LD665H - Manual (Page 151)

12 206-4200
Typical Installer Menu
Note: The Installer Menu header will vary
depending on the TV you are setting up.
Adjust the settings for these
Installer Menu items.
Master TV Setup Procedure
1. Set Installer Menu items.
This step provides specific instruction only on the Installer Menu
items that should be set on a Master TV. Refer to pages 15 to 22
for detailed information on all Installer Menu items.
a) Make sure the TV is ON. Then, use the Installer Remote to
enter the PTC Installer Menu: Press MENU repeatedly until
the on-screen display of the TV setup menus no longer
toggles, and then press 9-8-7-6 + ENTER.
b) Set Installer Menu item 117 FACT DEFAULT to 001 and press
ENTER on the Installer Remote.
This clears all Installer Menu custom settings, channel lineup,
etc. and reloads the factory default settings. The value will
change back to 0 after the PTC has been restored to factory
default condition. This step ensures that the TV Channel
Memory will be the active channel lineup.
c) Set Installer Menu item 003 BAND/AFC, as appropriate.
• Broadcast: Set to 000. • HRC: Set to 002.
• CATV: Set to 001 (default). • IRC: Set to 003.
d) Set any other Installer Menu items that affect your TV pro-
gramming network to the required configuration. For example,
enable/disable Aux inputs , set a Start Channel, etc.
e) After you have adjusted all required Installer Menu item
settings, press ENTER once on the Installer Remote to save
your changes; then, press ENTER again to exit the menu.
2. Set up TV features.
On-screen setup menus control the features of the TV. Press
MENU on the Installer Remote to access the TV setup menus,
and then set Channel, Picture, Audio, Lock, Time, etc. options to
the desired configurations. See also the Clonable TV Setup Menu
Features list on page 11.
Note: If you intend to clone the PTC, remember that only one TV
source’s clonable setup menu settings will be cloned. Thus, for a
clone programmer, the TV setup menu settings should be applica-
ble to either an analog channel or Aux input, while for a USB
device / .tll file, the TV setup menu settings should be applicable
to the analog or digital channel or Aux input to which the Target
TV will be set during the Teaching process.
Note: If desired and if appropriate depending on the cloning
method you intend to use (see “Cloning Methods” on previous
page), you can run Auto Tuning (see step 3) prior to completing
this step.
(Continued on next page)
xxLD66xH PTC INSTALLER MENU
000 INSTALLER SEQ 000
UPN 000-000-000-000 ASIC D279
PTC V1.00.016 CPU V1.21.00
117 FACT DEFAULT 001
003 BAND/AFC 00X
Master TV Setup (Cont.)
Use the TV setup menus to set the TV
features to the desired configuration
for the end user.
PICTURE AUDIO
INPUT OPTION
TIME
USB
CHANNEL
LOCK