LG 37LD665H - Manual (Page 176)

37 206-4200
1. Plug the USB memory device that contains the FTG Configuration
file into the Target LD660H/LD665H or LV555H TV USB IN port.
2. Press MENU on the Installer Remote to display the TV setup
menus (TV is in Pass-through Mode) or the Function Menu (TV is
already in FTG Mode).
3. Use the arrow navigation keys to select/highlight either the Option
menu icon from the TV setup menus or the Lock menu icon from
the Function Menu. Then, press the number “ 7” key a total of seven
times to display the USB Download Menu.
4. Use the Up/Down arrow keys to select Teach To TV (TLX), and then
press ENTER.
5. Use the Up/Down arrow keys to select the FTG Configuration file
you want to install, and then press ENTER.
The TV will show Teaching completion progress in a new window.
Do NOT remove the USB device until Teaching is complete. When
Teaching is complete, the TV will tune to the first logical channel in
the FTG Channel Map.
6. When Teaching is done, remove the USB memory device. The
FTG Configuration should be resident on the Target TV. Also, the
Target TV CPU is now in FTG Mode (if it was previously in Pass-
through Mode).
Teach To TV (TLX)
xxLD660H-UA00005.TLX
Return Enter
USB Download Menu
Upgrade TV Software
Upgrade PTC Software
Teach To TV (TLL)
Teach To TV (TLX)
Return Enter
Teach To TV
UPDATING...
Do not unplug!
!
50%
Teaching FTG Configuration to a TV
This procedure describes how to “Teach” an FTG Configuration file from a USB memory device to a TV.
Ensure you have completed the procedure on the previous page to create the FTG Configuration file
before proceeding with the steps below.
Notes: • If the TV is not in FTG Mode, but both Pro:Centric items (098 PRO:CENTRIC and 119 DATA
CHANNEL) have already been set in the Installer Menu on a TV, Teach to TV options will not
be available from the USB Download Menu.
• If the TV EBL is already in FTG Mode, you cannot use this procedure to make changes to
the FTG Channel Map and FTG Installer Menu settings. You must use a direct PC-to-TV
connection as described on page 40 or an FMA head end device to reconfigure the EBL.
• If either of the preceding conditions applies, but you wish to switch the TV to FTG mode via
CPU, refer to Reference section, “Resetting Factory Defaults on the TV(s),” for further
information before proceeding.
FTG Mode via CPU (Cont.)