LG 22LG3DCH - Manual (Page 93)

COMMER
CIAL
MODE
SETUP
91
COMMERCIAL MODE SETUP
INSTALLER OVERVIEW
O Op peerraattiin ng g IIn nssttaalllleerr M Meen nu u
To set up the controls for the TV you will need to know how to
enter the TV Installer menu and make changes to the default val-
ues. If necessary, familiarize yourself with the TV Installer menu
and how to make and save changes to the items in the menu.
LLG G IIn nssttaalllleerr R Reem mo ottee
You will need an LLG G IIn nssttaalllleerr rreem mo ottee control similar to the
one shown to the right. The installer remote must have a “Source”
button or its equivalent. The remote shown for reference in this
manual has “INPUT” -- this button serves the purpose of a Source
button.
The TV’s clonable features need to be set up. This is a critical
step. If the Master TV display panel’s clonable features like added
channel icons or channel labels are not done correctly, then the
cloned TVs will all have problems. Refer to the TV menus for
other TV features: Picture, Audio, Option, Closed captions, Lock
(V-Chip), etc.
T TLLLL--1 11 10 00 0A A C Cllo on nee P Prro og grraam mm meerr
The TLL-1100A is a very simple cloner to use. It
can be set up to clone a master TV setup and
transfer it into a target TV. Cloning is possible
using MPI protocol. Be sure the Master TV is
set up completely. Cloning is only possible
when the signal source is an Analog channel,
not a digital channel. Refer to TLL-1100A
instruction manual supplied with the cloner.
Typical Installer Menu
TV Link
Loader-Demo
TLL1100A
Ready
TLL1100A
ENTER
RECEIVE SEND
MENU MODE
ENTER
TV TV
INPUT
INPUT MODE
DVD
MULTI
EXIT
VOL
EZ SOUND INFO SWAP EZ PIC
TIMER
MUTE
CH
SAP
CC RATIO
MENU
VCR
POWER
1 2 3
4 5 6
7 8 9
0 FLASH
BACK
PAGE
000 INSTALLER SEQ 000
UPN 000-000-000-000 FPGA E0F1
PTC V1.00.000 CPU V3.06.00
HOSPITAL PTC INSTALLER MENU