LG LBC20514SW - Manual (Page 10)

9
REFRIGERATOR DOORS: HOW TO REMOVE AND REVERSE (Optional) For models with Pull Out Drawer
You may find it more convenient to have the doors converted from the left-opening type (factory installed) to the
right-opening type. Directions refer to the right side as your right when facing the unit.
TOOLS YOU MIGHT NEED OR USE
10 mm
1/4 in 1/4 in
3/8 in 3/32 in
Hex Socket Wrench Phillips Screwdriver Flat Head Screwdriver Allen Wrench
Other necessary tools are:
• 1/4 inch socket wrench.
• Adjustable Wrench.
• 10 mm open-end wrench
• Flat 2 inch putty knife
IMPORTANT: Before you begin, unplug the refrigerator or disconnect the power source. Remove all food and any
adjustable racks from the refrigerator doors.
HOW TO REVERSE DOOR SWING (when converting from left-opening side mode to right-opening mode).
1. Removing Refrigerator Door
• Gently pry the top hinge cover with a flat head
screwdriver and remove it (1).
• Using 10 mm socket wrench, remove the three bolts
and lift off the top hinge. Set parts aside (2).
• Remove the pivot (3) and the cap (4) and place them
in the opposite side.
• Gently lift the refrigerator door (5) and remove it.
• Once the door has been removed, remove the screws
(6), the stopper (7) and the hinge pin (8) located below
the door and remove the hinge (9).
• Install the hinge (10) on the opposite side of the door,
replace the screws (11), the stopper (12) and hinge pin
(13).
• Using the 1/4 inch socket wrench, loosen the pin (14)
and remove it.
• Remove the four screws (15 & 16) and remove the
hinge (17).
5
1
2 3
4
6
7
8
9
10
13
12
11
REFRIGERATOR INSTALLATION REFRIGERATOR INSTALLATION
14
15
16
17