LG LBC20514SW - Manual (Page 12)

11
HOW TO REMOVE AND INSTALL THE PULL OUT
DRAWER
IMPORTANT: To avoid possible injury or damage to
the product or your property, please use two people to
perform the following instructions:
1. Removing the Pull Out Drawer
• Pull the drawer out to maximum extension. Remove
the bottom rack (1) by tilting it back a little and then
lifting it off the railing tracks.
• Put pressure on the two hangers (2) with your thumbs
in order to lift it up.
• Separate the left and right rail cover.
• Remove the screws (3) from both sides of the rail track.
• With both hands, hold both sides of the door and pull
up to separate it.
• With both hands, hold the center of the bar and push
it in so that it is fit to both rails simultaneously.
CAUTION: When removing the drawer, do not hold
the handle. If it comes off, it could cause personal
injury.
CAUTION: To place the drawer on the floor, take
care not to damage the floor or hurt your feet with
the sharp edges on the side with the hinges.
2. Installing the Pull Out Drawer
• With both hands, hold the center of the bar and pull it
outward so that the two rails extend out at the same
time.
• Mount door supports (1) into the tabs on the railing
track (2), starting in the back first and then connecting
the part in the front last, as shown in the figure.
• Push the drawer down into position and tighten the
screws (3).
1
2
3 1
2
REFRIGERATOR INSTALLATION REFRIGERATOR INSTALLATION
3