LG LRE3012SW - Manual (Page 16)

- 16 -
1. Press WARM pad for 3 seconds.
2. Press “3” pad. The display will
show “BEEP Hi”.
3. Press “3” pad to switch beeper
volume (Hi, Lo, OFF).
4. Press START pad to accept the
desired change.
To set beeper volume
SETTING BEEPER VOLUME
The beeper volume feature allows you to adjust the volumes
to a more acceptable volume. There are three possible
volume levels.
1. Press WARM pad for 3 seconds.
2. Press “2” pad. The display will
show “Unit F”.
3. Press “2” pad to switch between
the “F” and “C”.
4. Press START pad to accept the
desired change.
To change display from Fahrenheit to Centigrade or
Centigrade to Fahrenheit:
SETTING TEMPERATURE UNIT —
FAHRENHEIT OR CENTIGRADE
WARM pad control the Fahrenheit or Centigrade
temperature display modes. The oven control can be
programmed to display temperatures in Fahrenheit or
Centigrade. The oven has been preset at the factory to
display in Fahrenheit.
1. Press and hold START for
3 seconds.
2. 2 beeps will sound, "DOOR
LOCKED" will flash in the display.
Once the oven door is locked the
"DOOR LOCKED" indicator will
stop flashing and remain on along
with the lock icon( ) light.
To activate the Oven Lockout feature:
1. Press and hold START for 3
seconds. A beep will sound
2 times. The "DOOR LOCKED"
will continue to flash until the oven
door has completely unlocked and
the lock icon( ) light will clear.
2. The oven is again fully operational.
To reactivate normal oven operation:
SETTING OVEN & COOKTOP
LOCKOUT FEATURE
The START pad control the Oven & Cooktop Lockout
Feature. The Oven & Cooktop Lockout feature automatically
Locks the oven door and prevent the Warming drawer,
cooktop elements and most oven controls from being turned
ON. It does not disable the clock, timer or the interior oven
Light.
1. Press and hold WARM pad for
3seconds. “OPt” will be displayed.
2. Press “1” pad. The display will
show “CLO 12H”
3. Press “1” pad to switch between
the “12H” and “24H”.
4. Press START pad to accept the
desired change.
Changing between 12 or 24 hour time of day
CHANGING HOUR MODE ON
CLOCK(12hr, 24hr)
Your control is set to use a 12-hour clock. If you would prefer
to have a 24-hour time clock, follow the steps below.
OPERATION (OPTIONS)