LG LUV350P - Manual (Page 19)

ENGLISH
19
y Electrical shock and personal injury hazard.
y Always unplug the power cord from the electrical outlet before servicing. Failure to do so could result in electrical shock or personal
injury.
WARNING
TROUBLESHOOTING
Problem Possible Causes Solutions
Vacuum cleaner will not run. Vacuum unplugged at wall outlet. Make sure cord is plugged into a functioning outlet.
Agitator motor overload protection. Unplug the vacuum cleaner and check the agitator for
obstructions and reset the unit.
Thermal protector activated. Allow the vacuum cleaner to cool down.
Poor dirt pickup. Full or clogged dust tank. Empty dust tank and clean filters.
Dust tank improperly installed. Make sure all dust tank components and filters are installed
correctly.
Clogged hose, wand or head. Check for clogs.
Belt broken/not installed properly. Check belt and replace if needed.
Agitator motor overload protection activated. Unplug the vacuum cleaner and check the agitator for
obstructions. Press the reset button.
Hole in hose. Inspect hose carefully. Replace if needed.
Worn agitator. Contact service.
Agitator does not turn Switch is off (unit is in floor mode). Turn on agitator power switch.
Cleaner is in upright position. Press the body release and tilt until back.
Agitator motor overload protection is tripped (brush
is jammed). Unplug the vacuum cleaner and check the agitator for
obstructions and reset the unit.
Belt is broken. Replace belt.
Dust escapes the dust tank. Dust tank improperly installed. Make sure all dust tank components and filters are installed
correctly.
The dust tank lid is not closed. Check the dust tank lid.
The bottom plate is not latched. Make sure the bottom plate is closed and latched.
Agitator on pet hair turbine
tool will not run when
attached. Dirty agitator or agitator supports. Clean the inside of the pet hair turbine tool.
Obstruction in turbine air path. Clean the inside of the pet hair turbine tool.
Low suction from vacuum cleaner. Check for clogs.
Accessory has no suction
when using with the handle. Main wand still connected to body base. Remove wand.
Dust tank feels loose when
lifting by the carry handle. This is normal. The vacuum is designed like this to prevent the tank from
separating
Review this section to find do-it-yourself solutions for minor performance problems. Any service or repair needed, other than as described in this owner’s
manual, should be performed through your local LGE service center.