Asus NCCH-DR - Manual (Page 79)

A S U S N C C H - D R A S U S N C C H - D R A S U S N C C H - D R A S U S N C C H - D R A S U S N C C H - D R 4 - 1 7 4 - 1 7 4 - 1 7 4 - 1 7 4 - 1 7
4.3.1 4.3.1 4.3.1 4.3.1 4.3.1 Primary IDE Master Primary IDE Master Primary IDE Master Primary IDE Master Primary IDE Master
Primary Master
Primary IDE Master [Auto]
Access Mode [Auto]
Capacity 0 MB
Cylinder 0
Head 0
Precomp 0
Landing Zone 0
Sector 0
PIO Mode [Auto]
UDMA Mode [Auto]
Transfer Mode None
S.M.A.R.T Status None
Select Menu
Item Specific Help
Selects the type of
fixed disk connected to
the system. ‘Manual’
will let you select the
number of cylinders,
heads, etc.
Note: PRECOMP=65535
means none!
Primary IDE Master [Auto] Primary IDE Master [Auto] Primary IDE Master [Auto] Primary IDE Master [Auto] Primary IDE Master [Auto]
Select [Auto] to automatically detect an IDE drive. If automatic detection
is successful, the setup BIOS automatically fills in the correct values for the
remaining fields on this sub-menu.
If automatic detection fails, this may be because the IDE drive is too old or
too new. If the drive was already formatted on a previous system, the BIOS
may detect incorrect parameters. In these cases, select [Manual] to
manually enter the IDE drive parameters. Refer to the section “Manually
detecting an IDE drive.”
If no drive is installed or if you are removing a drive and not replacing it,
select [None]. Configuration options: [None] [Auto] [Manual]
The IDE drive information items are grayed out when this item is set to
[Auto].
Access Mode [Auto] Access Mode [Auto] Access Mode [Auto] Access Mode [Auto] Access Mode [Auto]
Allows selection of the sector addressing mode. The default [Auto] allows
automatic detection of an IDE drive. Set this item to [CHS] if the P r i m a r y
P r i m a r y P r i m a r y P r i m a r y P r i m a r y
I D E M a s t e r I D E M a s t e r I D E M a s t e r I D E M a s t e r I D E M a s t e r item is set to [Manual] so you can manually enter the drive
values. Configuration options: [CHS] [LBA] [Large] [Auto]
PIO Mode [Auto] PIO Mode [Auto] PIO Mode [Auto] PIO Mode [Auto] PIO Mode [Auto]
Sets the PIO mode for the IDE drive. The settings Mode 0 to 4 allow
successive increase in performance. Configuration options: [Auto]
[Mode 0] [Mode 1] [Mode 2] [Mode 3] [Mode 4]