Connect equipment and power to the ups – American Power Conversion 2200 VA User Manual
Page 5
3
Connect Equipment and Power to the UPS
Startup
1. Connect equipment to the UPS. A laser printer draws significantly more power than other types
of equipment and may overload the UPS.
2. Add
optional
accessories to the Smart-Slot.
3. Plug the UPS into a two-pole, three-wire, grounded receptacle only. Avoid using extension
cords.
230 V model: The power cord is supplied in the UPS cable kit. The TVSS ground, located on the
rear panel of the UPS must be connected prior to connecting the utility power.
4. 120 V model: Check the site wiring fault LED
located on the rear panel. It will be illuminated
if the UPS is plugged into an improperly wired utility power outlet, (see Troubleshooting).
5. Turn on all connected equipment. To use the UPS as a master on/off switch, be sure all con-
nected equipment is on.
6. Press
the button on the front panel to power the UPS.
•
The battery charges to 90% capacity during the first four hours of normal operation. Do not
expect full battery run capability during this initial charge period.
7. For optimal computer system security, install PowerChute Smart-UPS monitoring software.
Rear Panels
100/120
V
208 V
230 V