Asus Dual TualatinTM Motherboard TRL-DLS - Manual (Page 25)

25
3. HARDWARE SETUP
ASUS TRL-DLS User’s Manual
3. H/W SETUP
Connectors
3) Wake-On-LAN Connector (3-pin WOL_CON)
This connector supports a LAN card with a Wake-On-LAN output. The connector
powers up the system when a wakeup packet or signal is received through the
LAN card.
IMPORTANT: This feature requires that the BIOS item Onboard LAN Power
Up is enabled (see 4.5.1 Power Up Control) and that your system has an ATX
power supply with at least 720mA +5V standby power.
2) Floppy Disk Drive Connector (34-1 pin FLOPPY)
This connector supports the provided floppy drive ribbon cable. After connecting
the single end to the board, connect the two plugs on the other end to the floppy
drives. (Pin 5 is removed to prevent inserting in the wrong orientation when
using ribbon cables with pin 5 plugged).
TRL-DLS
®
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.
TRL-DLS Floppy Disk Drive Connector
PIN 1
TRL-DLS
®
TRL-DLS Wake-On-LAN Connector
IMPORTANT: Requires an ATX power
supply with at least 720mA +5 volt
standby power
WOL_CON
+5 Volt Standby PME
Ground