Asus Dual TualatinTM Motherboard TRL-DLS - Manual (Page 60)

ASUS TRL-DLS User’s Manual 60
4. BIOS SETUP
4. BIOS SETUP
Boot Menu
Plug & Play O/S [No]
This field allows you to use a Plug-and-Play (PnP) operating system to configure
the PCI bus slots instead of using the BIOS. When [Yes] is selected, interrupts may
be reassigned by the OS. When a non-PnP OS is installed or you want to prevent
reassigning of interrupt settings, select the default setting of [No]. Configuration
options: [No] [Yes]
Reset Configuration Data [No]
The Extended System Configuration Data (ESCD) contain information about non-
PnP devices. It also holds the complete record of how the system was configured the
last time it was booted. Select [Yes] if you want to clear these data during the Power-
On-Self-Test (POST). Configuration options: [No] [Yes]
MPS 1.4 Support [Enabled]
This field allows you to enable or disable the MultiProcessor Specification 1.4 support.
Configuration options: [Disabled] [Enabled]
Quick Power On Self Test [Enabled]
This field speeds up the Power-On-Self Test (POST) routine by skipping retesting a
second, third, and fourth time. Configuration options: [Disabled] [Enabled]
Boot Up Floppy Seek [Enabled]
When enabled, the BIOS seeks the floppy disk drive once during bootup.
Configuration options: [Disabled] [Enabled]