HP ProLiant Support Pack (User Guide) - Manual (Page 31)

Possible values Description Parameter
ServerNotFound, BadPassword,
FailedDependencies Causes the installation to continue and
ignore errors. IGNOREERRORS
The ServerNotFound option can be used
to bypass inactive or unavailable remote
hosts when deploying firmware or software
to multiple remote hosts at the same time.
Use FailedDependencies to ignore any
failed dependencies and proceed with the
ones that are ready to be installed.
Directory path Provide a single local repository path. This
action creates an inventory from the given SOURCEPATH
path instead of the local or default
repository.
YES , NO This is a filter switch for use with bundles.
The parameter enables you to use the latest USELATEST
version of the bundle when multiple versions
of bundles are listed on the command line.
If no bundles are specified on the command
line, and multiple bundles are in the
directory, this parameter enables HP SUM
to use the bundle that has the latest version
for installation.
YES , NO Simulates the installation for a test run.
Nothing is installed. DRYRUN
One or more CLI switch Specify the HP SUM CLI options inside the
input file, which overrides the configuration OPTIONS
settings. Parameters can be separated by a
semi-colon, comma, or a space.
This parameter replaces the LSPOPTIONS
parameter that was previously supported
with LDU.
YES , NO Specifies that components that use SNMP
protocol, are available to be selected for
installation. USESNMP
These components are available for selection
by default. When the /usesnmp parameter
is used, and the /usewmi parameter is not
used, the WMI components are optional.
This parameter does not apply to HP Integrity
servers.
YES , NO Specifies that components that use WMI
protocol are available to be selected for
installation. USEWMI
These components are optional by default
and are not installed unless this parameter
is used. When the /usewmi parameter is
used, and the /usesnmp parameter is not
used, the SNMP components are optional.
This parameter does not apply to HP Integrity
servers.
YES , NO This is a filter switch that allows you to view
only the firmware components required for
installation. ROMONLY
Do not use the /romonly parameter with
the /softwareonly parameter.
Input files 31