HP StoreEver Ultrium Tape Drives - Manual (Page 28)

2. Ensure blanking plates are in place over empty bays and replace the cover on the server.
Reboot the server
Reboot the server to power up the tape drive and server.
Watch the boot screen carefully after installation. If there are any error or unexpected messages
go back and check the SAS cabling carefully.
•
Have you installed the SAS cable correctly?
•
Have you reconnected all devices securely?
If this does not resolve the problem, refer to Troubleshooting (page 48) for further guidelines.
28 Installing an internal LTO Ultrium tape drive