HP ProLiant Network Adapter Scripting Utility (User Guide) - Manual (Page 12)

Configuration properties 12
the driver adjusts the adapter's interrupt setting to achieve that DPC rate. Changing this setting may
improve performance for some configurations.
• EnablePME—Allows the use of power management and wake-up functions.
• SmartPowerDown—Minimizes power consumption by enabling the adapter to enter a deep sleep
mode under certain conditions.
• DefaultVlanId—Determines the VLAN ID used for any un-tagged packets received by the adapter. This
only applies to adapters that have VLANs defined.
• DefaultVLANTag—This feature adds a VLAN tag to the Default/Native VLAN packet.
Team configuration properties
Team configuration properties that are configured on the target server include the following:
• TeamName determines the unique identifier for the adapter team. Each team name on the target system
must be unique.
• OpMode determines the operating mode of the team. Possible values are Auto, DynamicSingleSlb,
StaticSingleSlb, TransmitLoadBalancing, TLBwithPref, FailOnFault, and PrefPrimary.
• LoadBalAlgorithm determines the team load balancing algorithm. Possible values are MACAddress,
IPAddress, TCPConnection, RoundRobin, and Auto.
• TeamNetworkAddress establishes the MAC address for the adapter team. A null value is always written
to the XML data file because locally administered addresses must be unique. A null value is valid and
computes a default address. This value must be a valid unicast address if it is edited.
• TxPathValidationMode enables or disables the packet signal transmitted between the teamed adapters.
• RxPathValidationMode enables or disables the packet signal received between the teamed adapters.
• TxPathValidationInterval determines how frequently the packet signals are transmitted. The range of
acceptable values is 3 to 60. Values less than 3 are set to 3, and values greater than 60 are set to 60.
• RxPathValidationInterval determines how frequently the packet signals are received. The range of
acceptable values is 3 to 60. Values less than 3 are set to 3, and values greater than 60 are set to 60.
• RxPathValidationVlanId determines the VLAN on which Receive Path Validation packet frames are
transmitted. This value is only written when a VLAN is defined for the team. The default is the VLAN on
the team with the lowest VLAN ID at the time the team is created.
• DefaultVlanId determines the VLAN ID used for any un-tagged packets received by the team. This
property only applies to teams that have VLANs defined.
• DefaultVLANTagging adds a VLAN tag to the Default/Native VLAN packet. DefaultVLANTagging is
supported on Windows Server 2008 systems only.
• TOEEnabled enables the offloading of TCP connections to HP Multifunction Server Adapters. The
TOEEnabled property is only valid when all the team members support TOE. Possible values are
0=Disabled and 1=Enabled.
• RSSEnabled enables dynamic load balancing of incoming traffic across CPUs. Possible values are
0=Disabled and 1=Enabled.
• JumboPacket indicates the size in bytes of the largest supported Jumbo Packet (an Ethernet frame that
is greater than 1514 bytes) that the hardware can support.