HP Intelligent Management Center Licenses - Manual (Page 29)

Configuration procedure
1. Click the Service tab on the top navigation bar, and then select VPN Deployment > Deployment
Tasks in the navigation tree to enter the deployment task list page.
2. Click the Modify icon of the deployment task that you want to modify.
3. You will enter the deployment flow of the task and do the modifications. The deployment flow
may be VPLS Deployment VLL Deployment PBB Deployment or Undeployment, depending
on the deployment operation type of the task.
Precautions
•
Deployment tasks with the deploy operation type of Add VPN or Modify VPN can be modified.
Deployment tasks with the deploy operation type of Undeploy VPN cannot be modified.
•
Deployment tasks in the state of Undeployed and Failure can be modified. Deployment tasks
in the state of Success and Deploying cannot be modified, and the system does not provide
the modify link for such deployment tasks.
•
The configuration for a VPN cannot be modified. To change the VPN name or description,
go to the VPN list. For more information, see Modify VPN.
•
If a deployment task contains configuration for multiple devices, the initial configuration is
displayed on the deployment taks modification page. The configuration commands that have
been deployed to devices are grayed out. The configuration commands not deployed to
devices or failing to be deployed to devices can be modified.
Automatic Discovery
This function can discover VPNs that exist on devices but yet are not added to the L2VPN Manager,
and then add the VPNs to the L2VPN Manager.
Discover VPN
This function is used to find VPNs and links existing on the network according to the VSI information
of PE devices. If you repeat to perform the automatic discovery operation, this function also can
sense the changes of the VPN structure and synchronize the changes to the topology.
Operation Procedure
1. Select the Service tab, and then click Automatic Discovery in the navigation tree to enter the
VPN automatic discovery page.
2. Click Select PE and on the pop-up page, select one or more PE devices, and then click Start.
3. The system starts automatic discovery. After the system finishes the automatic discovery process,
click Next. All discovered VPNs (LDP or BGP VPNs) will be listed.
4. Select VPNs that need interface configuration, and then click Next to enter the Configure
Interface Binding Information page.
Configuration Guidelines
•
For the PE devices selected, you can click Delete to delete them together.
•
When you click Select PE again, the selected devices will not be listed in the pop-up device
selection page.
Using L2VPN Manager 29