HP Intelligent Management Center Licenses - Manual (Page 88)

•
Ping the peer CE device on the local PE device to decide whether the link between them is
connected.
•
If all the above are connected, inter-CE link is connected; otherwise, inter-CE link is not
connected.
Operation procedure
1. Click the Service tab, click MPLS VPN Manager, and then click VPN Resources > VPN
Management in the navigation tree, and click the Audit Status link or the Audit Result link of
the intended VPN.
2. Select the CE-CE link to be audited in VPN link audit information list, and click Audit
immediately.
3. After audit is completed, click the Connectivity Status link on the VPN Audit Details page to
enter the Inter-CE Connectivity Audit page to view the details.
Precautions
•
When no IP address is available for the non-managed CE, if the PE interface connecting a
non-managed CE is down, the link is not connected; otherwise, it is connected.
•
Connectivity audit is performed per VPN. If MVM is auditing connectivity of some CE-CE links,
connectivity of the VPN or the links in the VPN can be triggered only when connectivity audit
of all the CE-CE links is completed.
Configuration audit
Configuration Audit compares the network management configuration of the device with the
currently synchronized configuration. If inconsistent, results are displayed. The Configuration
changed page displays information of the devices on the two ends of the link and link configurations.
The link configurations include network management configuration and current configuration of
the device.
Operation procedure
You can use the following approaches to view configuration audit information:
•
Approach 1:
Click the Service tab, click MPLS VPN Manager, and then click VPN Resources > VPN
Management in the navigation tree, in the VPN list, click the Access Topology link of the
intended VPN or click Global Topology in the navigation tree. 1.
2. Select the specified link in the Global Topology or Access Topology, and right-click to
select View Configuration Change Information.
•
Approach 2:
Click the Service tab, click MPLS VPN Manager, and then click VPN Devices > PE Device
List in the navigation tree. 1.
2. Click Query in the PE device list.
3. Click the Configuration Audit Status link on the page for displaying VPN information of
the PE.
Precautions
Configuration audit begins after device synchronization. Therefore, before querying configuration
audit information, you need to synchronize the PE where the link resides; otherwise, the configuration
change information you query may be incorrect.
88 MPLS Manager