HP xw4400 Workstation User Manual
Page 35
6.
Auto Configurations automatically adds all available disks to a RAID array, with the RAID level
determined by whether or not Redundancy is selected. Custom configuration lets you select disks,
array size, and RAID level. The next screen lets you select the disks that will be part of the RAID
array by creation of a "Disk Group" (or DG). Select from the available disks those disks that you
want to be part of the RAID array, and then click Accept DG to proceed.
Figure 6-11
LSI WebBIOS – Configuration of disk group
7.
When configuring the 9260-8i, a screen appears after you select Accept DG. This screen
prompts you to add the group to a Span, which is a virtual grouping. Normally, you add only one
DG to create one Span, or Virtual Device (VD). After creating a VD, you can move on to the next
screen where you configure the RAID attributes on the virtual device.
LSI 8344ELP, LSI 8888ELP, and LSI 9260-8i Setup
31
- xw6200 Workstation xw4550 Workstation xw8400-Workstation Workstation xw4100 xw6600 Workstation xw6400-Workstation xw8200 Workstation Z800 Workstation Z400 Workstation Workstation xw6000 xw4200 Workstation xw4600 Workstation xw3400 Workstation Z600 Workstation xw9300 Workstation xw4300 Workstation Workstation xw8000 xw8600 Workstation xw9400 Workstation