HP Neoware e140 Thin Client - Manual (Page 151)

6-67
Setup Menus
Lines are double height
Factory default: Unselected
This determines whether each line is single-height (normal) or double-height.
Lower case lockout
Factory default: Unselected
When selected, this will cause the LOCK key to be on so that only UPPERCASE
characters can be generated.
SOH clears screen
Factory default: Unselected
When selected, this will cause the Unisys T27 emulation to automatically clear the
screen whenever it receives an SOH character.
SOH exits forms
Factory default: Selected
When selected, this will cause the Unisys T27 emulation to automatically exit forms
mode whenever it receives an SOH character.
SO/SI XTN
SO/SI XLT
Factory default: Unselected
The setting of these options determine the effect of the ESC SO and ESC SI
sequences when receiving or transmitting data.
When receiving from the host, the setting of the SO/SI XTN option determines
whether the sequences are used to switch between standard and extended character sets
(selected), or reverse highlight and underline (unselected).
When transmitting to the host, the setting of both options determine the sequences
used for switching between standard and extended character sets, and reverse highlight
and underline as follows:
XTN XLT SO SI Extended Characters
Reverse Video Underline
Sent as Sent as Begin End
OFF OFF SO SI ESC SO ESC SI
ON OFF ESC’. ESC’/ SO SI
OFF ON ESC’. ESC’/ ESC SO ESC SI
ON ON ESC’. ESC’/ SO SI
The SO (shift out) and SI (shift in) sequences allow switching between two sets of
characters: the standard character set and the extended character set. Each set consists
of 128 characters. When an ESC SO sequence is received from the host, the emulation