HP Neoware e140 Thin Client - Manual (Page 191)

6-107
Setup Menus
Specifying Key Functions
You can cause a key function to be actioned by including the virtual key name of the
key enclosed by the < and > characters. You may omit the VK_ and VT_ parts (etc.)
of the virtual key name. For example, the Enter key would be specified as <ENTER>.
To send the function of a key combination, type the < character followed by the virtual
key names linked together with + characters and ending with the > character. For
example, Alt F4 would be specified as <ALT+F4>.
To send the function of a sequence of keys one after the other, enter each virtual key
name in the order required, enclosing each virtual key name with the < and >
characters. Each enclosed virtual key name must immediately follow the previous
enclosed virtual key name with no spaces. For example, F2 then F3 then F4 would be
specified as <F2><F3><F4>.
Specifying Characters
There are various ways in which you can specify a particular character. For example,
the ESC character can be specified using any one of the following five entries:
_027 Decimal value (underscore character followed by a 3-digit number).
\033 Octal value (backslash character followed by a 3-digit number).
\u001B Unicode value (backslash and u characters then unicode value).
^[ Control key value (^ represents the control key on the keyboard).
\e Additional value for ESC.
The following 'backslash' values can be used:
\u Unicode introducer \r Carriage return
\n Line feed \e Escape
Note that as the \ and ^ characters are used as value introducers, to enter these as
character values you need to precede them with a backslash character, i.e. enter \ as \\
and ^ as \^.
The Euro character can be specified by entering the unicode value \u20ac.