HP Neoware e140 Thin Client - Manual (Page 423)

C-53
Host Command Summary
LOCAL EDITING
Data block is cursor line ESC [ > 4 h
Data block is page(s) (depends on display memory) ESC [ > 4 l
Dump block data ESC 6
Enter character mode ESC [ > 2 l
Enter edit (block) mode ESC [ > 2 h
Modified unprotected areas only transmitted ESC [ > 6 h
Modified & unmodified unprotected areas transmitted ESC [ > 6 l
Page dump waits for host request ESC =
Transmission waits for host request ESC S
Transmit block data (excluding locked lines) ESC 5
Transmit selected areas ESC [ 17 l
Transmit unprotected areas (depends on modified mode) ESC [ 17 h
PRINTING
Auto print off ESC [ 4 i
Auto print on (data not displayed) ESC [ 5 i
Initiate page dump ESC [ > 2 i
Initiate screen transfer ESC [ > 1 i
Print & display received host data ESC [ > 3 i
Print screen ESC [ 0 i
Print screen qualified areas ESC [ > 0 i
REPORTS
Device control string (* = string) ESC P * ESC \
Display revision ESC $ Z
Report potentially destructive action to host ESC ] * ESC \
* = Reset to original state notification 0
Clear screen notification 2
Load keyboard table command failed 3
Load keyboard table command successful 4
Report terminal identity ESC [ c
Report terminal identity ESC [ 0 c
Report terminal status ESC [ * n
* = Ready 0
Report status 5
Report cursor position 6
VISUAL ATTRIBUTES
Change visual attributes of area ESC [ * p
* = Active position to end of area 0
Start of area to active position 1
Entire area 2
Change visual attributes of character ESC [ * q
Change visual attributes of display ESC [ * r
* = Active position to end of display 0
Start of display to active position 1
Entire display 2