HP Virtual Connect 8Gb 24-port Fibre Channel Module for c-Class BladeSystem - Manual (Page 93)

Command line 93
Item Description
Parameter
PortID (required) The ID of an uplink port to add. The ID is a combination of the enclosure name,
interconnect bay, and port number in a single descriptor. The format of the port ID is
<EnclosureID>:<InterconnectBay>:<PortNumber>.
Properties
Network
(required)
The name of an existing network to which the port is added if the shared uplink set
name is not specified
UplinkSet
(required)
The name of an existing shared uplink set to which the port is added if the network
name is not specified
Speed (optional) Specifies the port speed for the port (optional). Valid values include "Auto", "10Mb",
"100Mb", "1Gb", "10Gb", and "Disabled". If not specified, the default port speed is
"Auto". If no connector is present on the uplink port, only "Auto" and "Disabled" can
be configured as the speed. Speed restrictions apply.
Role (optional) The role played by the port if the connection mode of the network or shared uplink set
is selected as "Failover". Valid values include "Primary" and "Secondary". The default
is "Primary".
Examples
->add uplinkport enc0:1:1 Network=MyNetwork
Adds a new uplink port (Bay 1, Port 1) to a network named MyNetwork
->add uplinkport enc0:2:4 Network=MyNetwork Speed=1Gb
Adds a new uplink port (Bay 2, Port 4) to a network and sets the port speed
->add uplinkport enc0:2:3 UplinkSet=MyUplinkSet
Adds a new uplink port (Bay 2, Port 3) to a shared uplink set
->add uplinkport enc0:2:4 Network=MyNetwork Role=Primary
Adds a new uplink port to a network with the connection mode as Failover and the port
role as Primary
Item Description
remove uplinkport Remove an uplink port element from a network or a shared uplink port set.
Syntax
remove uplinkport <PortID> [Network=<NetworkName> |
UplinkSet=<UplinkSetName>]
Parameters
PortID (required) The ID of the port to remove from a network. The port ID must be in the format
<EnclosureID>:<InterconnectBayNumber>:<PortNumber>.
If EnclosureID is not specified, it defaults to the local enclosure.
Network
(optional)
The name of the network from which the port is removed
UplinkSet
(optional)
The name of the shared uplink set from which the port is removed
Examples
->remove uplinkport enc0:1:2 Network=MyNetwork
Removes a specific uplink port (Bay 1, Port 2) from a network named MyNetwork
->remove uplinkport * Network=BlueNetwork
Removes all uplink ports from a network named BlueNetwork
->remove uplinkport enc0:2:3 UplinkSet=SharedUplinkSet1
Removes a specific uplink port (Bay 2, Port 3) from a shared uplink set
Item Description
set uplinkport Modify an uplink port that exists as a member of a network or shared uplink port set.