Antec Quiet Computing Two Hundred - Manual (Page 6)

5
2.3 C ABLE M ANAGEMENT
There is a cable management compartment behind the 3.5” drive cage.
You can tuck or route excess cables in this compartment.
1.
Open the right side panel as described in section 2.1.
2. Locate the cable management compartment with cable ties located
behind the walls of the 3.5” drive cage.
3. Tuck or route your excess cables to the compartment. This will keep
the cables from interfering with airflow in your case and help with
cooling.
4. Use the cable ties provided to hold them in place.
2.4
M OTHERBOARD I NSTALLATION
1. Lay the case down, with the open side facing up.
The drive cages and power supply should be visible.
2. Make sure you have the correct I/O panel for your
motherboard. If the panel provided with the case
isn’t suitable, please contact your motherboard
manufacturer for the correct I/O panel.
3. Align your motherboard with the standoff holes and
remember which holes are lined up. Not all
motherboards will match with all the provided
holes; this is normal and won’t affect its
functionality.
4. Remove your motherboard by lifting it up.
5. Install standoffs as needed and put the
motherboard back in.
6. Screw in your motherboard to the standoffs with
the provided Phillips-head screws.
Note: The Two Hundred comes with a CPU cutout on the motherboard tray, which will allow you to
change your CPU heatsink without removing the motherboard.