Onnecting the, Ront, Orts – Antec Quiet Computing Two Hundred User Manual
Page 8
7
Pin
Signal Names
Pin
Signal Names
1
USB Power 1
2
USB Power 2
3
Negative Signal 1
4
Negative Signal 2
5
Positive Signal 1
6
Positive Signal 2
7
Ground 1
8
Ground 2
9
Key (No Connection)
10
Empty Pin
Pin
Signal Names
(HDA)
Pin
Signal Names
(AC’97)
1
MIC2 L
1
MIC In
2
AGND
2
GND
3
MIC2 R
3
MIC Power
4
AVCC
4
NC
5
FRO-R
5
Line Out (R)
6
MIC2_JD
6
Line Out (R)
7
F_IO_SEN
7
NC
8
Key (no pin)
8
Key (no pin)
9
FRO-L
9
Line Out (L)
10
LINE2_JD
10
Line Out (L)
2.7
E
XTERNAL
5.25”
D
EVICE
I
NSTALLATION
There are three externally accessible 5.25” drive bays. Before you begin,
remove both side panels and front bezel as detailed in section 2.1.
1. Remove the drive bay faceplate by applying pressure to the inside
of the plate until it pops free of the bezel.
2.
Slide your 5.25” device into the bay from the front of the case.
3. Secure the drive into position in the drive cage using the provided
screws.
4. Mount any other 5.25” devices accordingly.
5. Connect the appropriate power and data cables to your device(s).
C
ONNECTING THE
F
RONT
I/O
P
ORTS
3.1
USB
2.0
Connect the front I/O panel USB cable to the USB header pin on your motherboard. Check the
motherboard user’s manual to ensure that it matches the table below:
3.2
AC’97
/
HD
A
UDIO
P
ORTS
There is an Intel® standard 10-pin AC’97 connector and an Intel® 10-pin HDA (High Definition Audio)
connector linked to the front panel of the case.
10 6 4 2
9 7 5 3 1
1 2
9 10