Antec Quiet Computing Two Hundred - Manual (Page 7)

6
2.5 I NTERNAL 3.5” D EVICE I NSTALLATION
The Two Hundred provides space for up to six 3.5” hard
drives. Before you begin, remove the side panels and
front bezel of the case as described in section 2.1. Behind
the front bezel there is a fan cage which provides space
for up to two fans at the front of the case.
1.
Open the fan cage by pressing both clips to release
it, then swing it open and detach it from the chassis.
2. Insert your 3.5” device into the 3.5” drive cage from
the front of the case until the mounting holes align
with the screw holes in the cage.
3. Fasten the device in place with the provided screws.
4. Mount any other 3.5” HDD devices accordingly.
5. Connect the appropriate power and data cables to
the device(s).
6. Replace the fan cage.
2.6 F
RONT -L OADED H OT S WAP SATA H ARD D RIVE C ADDY
This case comes with a built-in, externally accessible 3.5” SATA
drive bay where you can load/unload your drive without shutting
down your computer.
Note: Before you can use the hot swap feature, you must
install all related drivers that come with your
motherboard and turn on the “AHCI” function in the
BIOS to activate the hot swap feature.
Loading:
1. Align your SATA HDD with the drive bay with the connector
facing the case.
2. Push the HDD all the way into the bay until it locks into
position.
Unloading:
1. Ensure that your HDD is not in use.
2. Push the release button on the left-hand side of the drive bay
and pull the HDD free.