Figure 5-5, Tape drive front view, Figure 5-6 – HP Integrity NonStop H-Series User Manual
Page 81: Rear view of the tape drive
Advertising
Installing and Configuring the Tape Drive for the HP
Integrity NonStop NS-Series Server
N1525A ACL Installation and User’s Guide — 527339-003
5 -5
Installation
5. Connect the larger end of the SCSI cable to SCSI port 1 on the rear panel of the
tape drive. See
for the location.
6. Tighten the screws by hand to secure the cable to the unit. Do not use a
screwdriver.
7. Connect the supplied differential terminator to SCSI port 2. See
for the
location.
Figure 5-5. Tape Drive Front View
Figure 5-6. Rear View of the Tape Drive
Power Switch
Port 1 Port 2 AC Power Receptacle
Advertising
This manual is related to the following products: