HP ProLiant ML350p Gen8 Server - Manual (Page 69)

Hardware options installation 69
The server exits standby mode and applies full power to the system. The system power LED changes
from amber to green.
15. Do one of the following:
o For tower models, install the bezel.
o For rack models, if removed, install the security bezel (on page 21 ).
Optical drive option
The server supports both DVD-ROM and DVD-RW drives.
1. Do one of the following:
o For tower models, open and remove the bezel (" Remove the tower bezel " on page 21 ).
o For rack models, if installed, remove the security bezel (on page 21 ).
2. Power down the server (on page 20 ).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. For tower models, do the following:
a. Place the server on a flat, level surface with the access panel facing up.
b. Remove the access panel (on page 23 ).
5. For rack models, do the following:
a. Extend the server from the rack (on page 24 ).
b. Remove the access panel (on page 23 ).
c. Release thumbscrews and remove the rack bezel.
6. Remove the blank from the drive cage.